Medical High Purity Injection Muscle Growth 58-20-8 Testosterone
Name: Testosterone cypionate
CAS No.: 58-20-8
Molecular Weight: 412.61
(6CI,7CI,8CI);Cyclopentanepropionic acid, ester withtestosterone
Density: 1.1 g/cm3
Boiling Point: 525.9 °C at 760 mmHg
Flash Point: 223.9 °C
Appearance: white to off-white crystalline powder
Effective Dose (Men): 300-2000mg+ week
Effective Dose (Women): Not recommended
Active life: 8 days
Detection Time: 3 months
Testosterone Cypionate Description
- Testosterone cypionate (Depo-Testosterone) is an inexpensive drug
used to support normal male development such as muscle growth,
facial hair, and deep voice. This drug is more popular than
- Testosterone cypionate is a long-acting version of the parent
hormone testosterone with an attached cypionate ester to delay its
release into the body. Testosterone is the most potent, naturally
occurring androgen that is formed in the human body. It is
responsible for characteristics specific to males and their sexual
Testosterone Cypionate Half-life
Testosterone Cypionate is the longest-estered testosterone
It has a half-life in the body of 15 to 16 days and is found as
injectable oil. Because it reacts in the body for so long, it can
cause more water retention than other steroids and is best used as
bulking compound in a stack.
Testosterone Cypionate : Dosages & Receipes
Give this a try. 50 ml @ 200 mg/ml
10g 1-test cyp powder
.22 or .45 whatmans
Cottenseed oil or GSO
steirile, sealed 50ml vial
unsealed 50ml vial
glass rod to stir.
Steroid Hormone Product list--Hubei Jusheng TC.pdf...
The steps for: making 1-Testosterone Cypionate into Steroids
1. put 50cc of water in the unsealed vial, and mark where that line
was with a marker, and set both vials side by side and mark on the
2. clean out unsealed vial with BA and let dry
3. add 10g 1-test cyp powder to unsealed vial
4. Add 12mls (NOT %) benzyl benzoate to powder
5. Add 3mls benzyl alcohol
6.. use glass rod to stir solution, while the powder starts to
7. put a pot of water on stove, and bring to a boil
8, add cottonseed Or GSO ,until it is about 3-4 ccs (estimate) shy
of the marker line.
9. put rubber stopper on unsealed vial, and put a 25g needle
10. put vial in boiling water until the solution is no longer
11. clean off sterile vial stopper with alcohol wipe, and put 25 g
needle through it.
12. useing filters, and 10cc sryinges, start to filter the solution
into the sterile vial.
13. when all the solution is in the vial, filter more cottenseed
oil though the SAME Filter, up to the marker line on vial. reason
for this is to push through any 1-test cyp left in the filter.
14. bake solution, with 25g needle in stopper, at 250 degrees for